How To Hotwire A 4 Wheeler?

If you have lost the keys to your 4-wheeler and need to start it, there is a method you can use to get it started quickly. Just make sure that the 4-wheeler belongs to you as hot-wiring a vehicle that does not belong to you could result in a long stint in the local jail. There are also other alternatives to getting your 4-wheeler going again if you're not comfortable fooling with electrical wiring.

Simply cut the wires that are attached to the ignition switch first. Then you'll need to find the key hot wire, that wire is most often colored red, and the wire that connects to the coil. Place a three-way pull-apart butt connector on the wire ends and then touch the ignition wire to the three way connection. After you have started the bike make sure to tape up the ignition wire so it does not touch anything else and short out.

To get your 4-wheeler started in a less dramatic way, call your local locksmith. The fees will vary but expect to pay at least $25 for a locksmith to come out to your location and craft a new key for you. It will only take about thirty minutes or so, and as soon as you get your new key immediately go and make a copy of it so you won't be stuck in this situation again.

Another thing you can do to get your 4-wheeler rolling again is to go back to the dealer where you brought the vehicle. Many dealers will be able to get a new key for you for a small fee, and once again, the first thing you should do as soon as you get a new key is to make a copy or two of it so you don't find yourself in this situation again down the road.

There are usually 4 wires to the ignition switch.  2 of them(usually red) start it, and the other 2(usually black or brown) will kill it.   Touch two wires together till the neutral light comes on(make sure it is in neutral first).  When you see the light come on twist those together and start it.  If you hear or see a spark and smoke, those aren't the right wires.  Probably the 2 red ones will work depending on what kind of 4wheeler you have

I do not now how to Hotwire a 4 wheeler

How to hot wire a predator 50 with a picture?

Yeah its easy you need to do is cut the wires on th bottom of the switch find the key hot wire and the wire that energizes the coil place a three way pull apart butt connector on the wire ends then find the ignition wire when you want to start the bike touch it to the three way connection. Make sure you can put the ignition wire up so it wont touch anything

There's nothing hard about it. I hot-wired my friend's banshee today because I wanted to ride and he lost the key. We simply cut all 4 wires to the ignition and wired them all together. The fourwheeler didn't want to start at first because it has been sitting for about 2 years but after a lot of kicks, it started up.